If you have been reading about CJC-1295 and want a single page that covers the useful parts, this is it: definitions, context, how it is studied, and the questions that come up repeatedly.
Last reviewed on 2026-05-29. Where a claim depends on a specific study, the study is described rather than over-claimed.
Two principal forms appear in the literature and in research supply. One carries a drug affinity complex, a maleimide-based group that forms a covalent bond with circulating albumin. This linkage slows clearance and produces a long-lasting elevation of peptide levels. The other form lacks that group and is often labeled MOD GRF(1-29). It has a much shorter circulation time. Both variants retain the same core receptor-binding sequence. Reported half-lives differ substantially between the two.
At the pituitary, the peptide binds the growth hormone-releasing hormone receptor on somatotroph cells. Receptor activation raises intracellular cyclic AMP and triggers release of stored growth hormone. Somatostatin and other hypothalamic signals modulate this response. Negative feedback from insulin-like growth factor 1 also influences output. The same regulatory architecture operates with the native hormone. Whether the synthetic analog alters feedback dynamics over repeated exposure remains an open question. Most published receptor work uses cell models rather than intact human systems.
CJC-1295 is a synthetic peptide built as a long-acting analogue of growth hormone-releasing hormone. Its backbone matches the first twenty-nine residues of the natural human hormone, with four amino acid substitutions added to slow enzymatic breakdown. A reactive maleimide group, commonly termed the drug affinity complex, allows the peptide to attach to circulating albumin after administration. That albumin attachment keeps the molecule in the bloodstream for an extended period instead of being cleared within minutes.
The compound emerged from work at a Canadian biotechnology firm in the early 2000s. Early human studies examined its effect on growth hormone and insulin-like growth factor 1 in healthy volunteers and in people with HIV-associated fat redistribution. Reports described sustained increases in both markers after a single injection. Development did not advance to regulatory approval, and the clinical programme was later discontinued. The molecule is now encountered mainly as a research chemical rather than a marketed medicine.
| Property | Value | Notes |
|---|---|---|
| Molecular weight, DAC form | About 3647 Da | Varies with salt form |
| Molecular weight, non-DAC form | About 3358 Da | MOD GRF(1-29) |
| Solubility class | Water soluble | Also dissolves in polar solvents |
| Reported half-life, DAC form | About five to eight days | Values from human studies |
| Common synonyms | CJC-1295; MOD GRF(1-29) | Name depends on variant |
Binding of the peptide to the growth hormone-releasing hormone receptor on pituitary somatotrophs triggers a G protein coupled cascade that raises cyclic AMP and opens calcium channels. The result is greater secretion of growth hormone into the bloodstream. Because the peptide acts at the same receptor as the natural hypothalamic hormone, its effect is amplified pulse size rather than an entirely separate release pathway. Receptor binding alone does not determine the response, since somatostatin tone and other inputs modulate the final output.
The albumin-binding version stays in circulation for days, because covalent attachment to serum albumin shields the peptide from rapid filtration and degradation. Reported half-lives for this form fall in the range of several days. The version without the linker is cleared in minutes, with estimates often near thirty minutes in animal work. These figures come from small studies and vary with assay method, species, and route, so they are best read as approximate rather than fixed constants.
Studies in this area generally track growth hormone pulses, insulin-like growth factor 1 concentrations, and occasionally body composition endpoints. Most published human data come from early, small trials, and questions about long-term effects remain open. Whether repeated exposure alters pituitary responsiveness over time is not settled. Analytical work relies on immunoassays for the hormones and on mass spectrometry for the peptide itself, because the two measurements answer different questions.
Research material is normally supplied as a freeze-dried powder in sealed vials. In that state the peptide is comparatively robust, but prolonged exposure to warmth, moisture, or light accelerates degradation. Storage at minus twenty degrees Celsius or lower, with desiccant and protection from light, is the commonly described practice. Vials should be allowed to reach room temperature before opening to limit condensation on the powder. Moisture uptake during handling is a recognized source of variability in later measurements.
Reconstitution is typically performed with sterile water or bacteriostatic water, added slowly against the vial wall. The resulting solution should be clear and colorless; cloudiness or visible particles suggest a problem with the material or the diluent. Once in solution, the peptide is less stable than the dry powder. Refrigerated storage at two to eight degrees Celsius is common for short-term holding, while freezing aliquots is described for longer periods.
=== Supercritical fluid decomposition === Supercritical water can be used to decompose biomass via supercritical water gasification of biomass. This type of biomass gasification can be used to produce hydrocarbon fuels for use in an efficient combustion device or to produce hydrogen for use in a fuel cell. In the latter case, hydrogen yield can be much higher than the hydrogen content of the biomass due to steam reforming where water is a hydrogen-providing participant in the overall reaction.
US575002A patent on 01.Dec.1897 to Alexander Lodyguine (Lodygin, Russia) describes filaments made of rare metals, amongst them was tungsten. Lodygin invented a process where rare metals such as tungsten can be chemically treated and heat-vaporized onto an electrically heated thread-like wire (platinum, carbon, gold) acting as a temporary base or skeletal form. (US patent 575,002). Lodygin later sold the patent rights to General Electric. In 1902, Siemens developed a tantalum lamp filament that was more efficient than even graphitized carbon filaments since they could operate at higher temperature. Since tantalum metal has a lower resistivity than carbon, the tantalum lamp filament was quite long and required multiple internal supports. The metal filament gradually shortened in use; the filaments were installed with large slack loops. Lamps used for several hundred hours became quite fragile. Metal filaments had the property of breaking and re-welding, though this would usually decrease resistance and shorten the life of the filament. General Electric bought the rights to use tantalum filaments and produced them in the US until 1913. From 1898 to around 1905, osmium was also used as a filament in lamps made by Carl Auer von Welsbach. The metal was so expensive that used lamps could be returned for partial credit. It could not be made for 110 V or 220 V so several lamps were wired in series for use on standard voltage circuits. These were primarily sold in Europe.
Biomolecular structure Mammalian Motif Finder MochiView Multiple EM for Motif Elicitation Nucleic acid sequence Protein primary structure Protein I-sites Sequence logo Sequence mining Structural motif Short linear motif Conserved sequence Protein domain
Sources: en.wikipedia.org
Chloroform Ethyl chloride Diethyl ether Ethane and ethylene Laughing gas (nitrous oxide) Poppers (alkyl nitrites) Solvents and propellants (including propane, butane, freon, gasoline, kerosene, toluene) along with the fumes of glues containing them
When the upper plate was connected to the negative pole of the battery and the lower plate to the positive pole, the glowing patch moved downwards, and when the polarity was reversed, the patch moved upwards.
== History == Dihydroergotamine was synthesized by Albert Hofmann and Werner Stoll at Sandoz in 1943. It was first described in the scientific literature that same year. Dihydroergotamine was first approved for medical use under the brand name D.H.E. 45 in 1946. Dihydroergotamine is derived from ergot, a fungus that grows on rye and other grains.
Sources: en.wikipedia.org
===== Flutamide ===== There is tentative evidence for flutamide in women; however, it is associated with relatively high rates of liver problems and strong recommendations have been made against its use. Like spironolactone, flutamide is typically only used by women. Bicalutamide is another option for the treatment of female pattern hair loss. It has a far lower risk of liver toxicity than flutamide and is said to have an excellent safety profile. However, bicalutamide retains a small risk of liver toxicity and for this reason periodic liver monitoring is recommended during treatment.
===== Methods ===== Methods of functionalizing the 4RepCT protein have been successful, but not in the way of reliably producing a stable protein functionalization in biologic environments that can also be tuned and modified. Genetic fusion of functional peptide sequences to silk genes and chemical conjugation of functional molecules onto amino acid side chains are the only two methods currently known to achieve a functionalized 4RepCT protein with tunable functionality. The first approach has the advantage that post-translational manipulation of the silk is minimized. Unfortunately, genetic manipulation is challenging due to the high GC (guanine-cytosine) content of the gene which leads to transcription errors. This method also limits the prevalence of functional binding sites to a single ligand-binding site per 25 kDa 4RepCT silk protein. Large adaptor proteins such as antibodies can be used to display more binding sites, but it isn't considered a feasible solution. This method has been shown to produce 4RepCT proteins that have a higher cell adhesion than natural spidroin proteins and have varied antimicrobial properties. The second method, chemical modification of the silk proteins should result in the covalent attachment of several copies of a wide range of organic and organometallic ligands using robust or sensitive linkers depending on the application. The challenge with this method is it is difficult to make the modification of the 4RepCT protein site-specific.
In 2014, BioMarin acquired a histone deacetylase inhibitor chemical library from Repligen for $2 million with the intention of advancing work toward therapies for Friedreich's ataxia and other neurological disorders. In November 2014, the company agreed to the acquisition of Prosensa for up to $840 million; however, the range of treatments for Duchenne muscular dystrophy failed to attain FDA approval, and development ceased in May 2016. In October 2019 it was revealed that the group will open an office in Dublin to support further growth through Europe, the Middle East and Asia. In December 2025, BioMarin agreed to acquire Amicus Therapeutics for $4.8 billion.
stazione della Ciriè-Lanzo), a former 19th-century railway station that marked the terminus of Ciriè-Lanzo railway line until the 1980s. To this day, the station is no longer in use as well as the rails up to Piazza Baldissera. The station building was recently renovated and now hosts some old locomotives, although it is not open to the public. Unfortunately, the old rails crossing the district are totally disused and neglected, adding decay to the whole area. Borgo Dora, as many other pockets of Aurora, is characterised by the marked multi-ethnicity of its population, being home to a large community of immigrants from emerging countries.
Sources: en.wikipedia.org
It is a synthetic peptide modeled on growth hormone-releasing hormone. The molecule is used in research on pituitary growth hormone secretion. It differs from the natural hormone through several stabilizing substitutions.
The DAC form carries a maleimide group that binds albumin and extends circulation time. The non-DAC form lacks this group and clears much faster. Both share the same receptor-binding core.
It targets the growth hormone-releasing hormone receptor on pituitary somatotroph cells. Activation raises cyclic AMP and promotes growth hormone release. Normal feedback pathways remain part of the response.
It is a synthetic peptide analogue of growth hormone-releasing hormone. Four substitutions in its sequence make it more resistant to enzymatic degradation than the natural hormone. In the version carrying a drug affinity complex, the peptide binds albumin and remains in circulation for days.